The equipment in the high temperature barrels have two rings are used in preparation for the lifting, but it can be seen to remove the roof. (See Picture 1)
１、The device need to be installed at the smooth ground floor,and fixed by fang bolt firmly.
２、 Equipment installed on the frame four adjustable supporter feet, leg contact with the floor, feed pump connect with the floor at the same standard, the level of axis must be corrected to prevent the vibration when used.
３、 All equipment connected to the pipeline should pay attention not to be subject to any external force, in particular, should be to eliminate the effects of thermal expansion
４、Feed pump to ensure the correctness of the direction of the electrical transmission. Operators face impeller, pump shaft should be rotating counter-clockwise, and test the rotation if is flexible by hand after installation.
５、When connecting to the homogeneous machines, the external pipe should be 14.7Mpa (150kgf/cm ²) of the pressure test shall not be leaking.
６、Tank overflow pipe need to connect with the ground and must be to prevent the washing liquid corrode the workshop surface.